Model: 3611

■ Loctite red plastic features

JSM3611 is a one-component epoxy resin adhesive for screen printing and rapid curing after heat. Its shear-thinning viscosity and non-volatility are suitable for stencil printing or SMT placement machines Dispensing, gel point shape is very easy to control, excellent heat resistance, without any solvent, in full compliance with environmental requirements.

Use

Typical Applications Pre-wave solder the surface mount components bonded to the printed circuit board for stencil printing (scraping glue) or used in SMT placement machine dispensing, in the requirements of high wet strength, high electrical performance occasions. This product has a particularly good adhesion to difficult-to-bond components such as clear glass diodes.

Curing characteristics

Before Curing Chemical Type: Epoxy Appearance: Dark Red Paste Specific Gravity @ 25 ° C: 1.25 Viscosity @ 25 ° C: mPa.sBrookfieldHATwithHelipathSpindleD: Relationship between Cure Speed and Temperature The graph in the figure below shows the difference between the curing temperature and Torsional strength achievable with time.

How to use

If the user is a 300ml large package, care must be taken not to allow the sundries and air to run in when dispensing into a small syringe package. Before using the dispensing nozzle, adapters and other accessories thoroughly cleaned to avoid cross-contamination with other epoxy glue or acrylic acid. Every time the replacement must be thoroughly clean plastic nozzle. Dispensing volume depends on the size of the working pressure, time, dispensing nozzle diameter and ambient temperature. These parameters vary with the dispenser model, and you need to optimize for the best spot.

■ storage method

This product should be refrigerated at -5 ℃ to 5 ℃, the unopened product in a dry place, refrigerated after the product must be returned to room temperature before use, 300ml packaged product storage life since the date of production of 6 months.

■ product packaging

Packaging: 200 / 300ml / branch